Articles
  • Porous Al2O3 catalyst carrier by 3D additive manufacturing for syngas reforming
  • N.C. Fana, Y.Y. Chena, K.Y. Chena, W.C. J. Weia, B.H. Liub, A.B. Wangc and R. C. Luod
  • a Department of Materials Sci. Eng., National Taiwan University 1 Roosevelt Rd. Sect. 4, Taipei, Taiwan 106, ROC b Department of Mat. Sci. Eng., National Cheng Kung University c Institute of Applied Mechanics, National Taiwan Univeristy d Department of Electric Eng., National Taiwan University
Abstract
A disk-shaped ceramic catalyst made by 3D printing (3DP) is used to reform syngas. We select two Al2O3 powders (α- and high-surface-area θ-Al2O3) and polymeric binders for preparing the 3DP feedstock. Catalyst stacked Al2O3 disks are made by kneading the polymers with ceramic powders and extruding to produce filaments, which are melted and used for 3D additive manufacturing (AM). The processing parameters (sequence of addition, viscosity of the feedstock, etc.), the phase transformation of the θ-powder, and catalytic properties of the made carrier are examined. The made alumina disks were densified to a relative density (RD) of 40% −65%. Two porous disks were coated with catalyst NiO and CeO2, and used to reform syngas made from waste paper. The best case reforms the CH4 content in the syngas from 25.7% down to 0.15% or lower. The reformed gaseous fuel is suitable for solid oxide fuel cells (SOFCs).

Keywords: Al2O3, catalyst, 3D printing, additive manufacturing, feedstock.

This Article

  • 2017; 18(9): 676-682

    Published on Sep 30, 2017